Installation overview

Installation Overview

Start with mat pattern and product variant, then confirm app requirements and on-site activation steps.

trailpulse trailpulse wide trailpulse plus trailpulse wide+

SCHRITT 01

Mat pattern & product page

Reference pattern 5 install steps Confirm product type

The carton print shows the reference pattern for correct mat installation. Complete the 5 steps in order (position, mark & dig, bury, compact, installer app), then select the product with the matching mat layout: trailpulse = 1 mat, trailpulse+ = 2 mats in line, trailpulse wide = 2 mats side-by-side across the trail, trailpulse wide+ = 4 mats in a 2x2 matrix.

Tip: Re-confirm mat pattern, location and product type before final compaction.

✓ Check printed mat pattern on carton
✓ Complete all 5 installation steps
✓ trailpulse: 1 mat
✓ trailpulse plus: 2 mats in line
✓ trailpulse wide: 2 mats side-by-side
✓ trailpulse wide+: 4 mats (2x2 matrix)
✓ Run one test pass before final closeout

Reference pattern

SCHRITT 02

App requirements (iOS & Android)

iOS + Bluefy Android + Chrome Installer app

A compatible mobile device is required for final verification: iOS with Bluefy or Android with Chrome. Make sure Bluetooth and location permissions are enabled.

Tip: Verify browser setup and permissions before traveling on-site.

✓ iOS device with Bluefy available
✓ or Android device with Chrome available
✓ Bluetooth enabled
✓ Location permission granted
✓ Installer app / installer web flow reachable

SCHRITT 03

Activate device in the field

Post-install Installer flow No video yet

After mechanical installation, activate the device on site in the installer app. Run multiple real passes, verify timestamps/response behavior, and only close the session after successful validation.

Tip: This section intentionally has no video yet until the final activation clip is available.

✓ Open installer and connect device
✓ Check measurement/status values
✓ Run multiple real-world test passes
✓ Finalize installation session
✓ Save report/log

Start device setup

In the Trailpulse dashboard, set up your device and project and start the installation flow. For the installer web app on site: iOS with the Bluefy browser, Android with Chrome — enable Bluetooth and location permissions.

Open device setup

Installation overview and requirements

Contact